Print

[johnyjf]

Hi Tom,
Where can you buy the Hand Controlleryou show?  It looks very neat.A quick look on eBay showed many thousands of car key fobe options but I couldn't find one of there.
John

[tombkk]

I 3D-printed hand-controller enclosure for the V4.6 PCB from ABS plastic (see 1:57 in the clip). I use a ATTiny85 Arduino board and a five-position switch for mode and speed selection (long-push = cycle through ST-4 - 2x - GOTO mode, click LEFT - RIGHT - UP - DOWN = R.A.- - R.A.+ - DEC+ - DEC-).  There is a red-green LED indicator to indicate the mode (green = ST-4, orange = 2x, red = GOTO). See 2:05 for details.

I also 3D-printed enclosure for 0.9° NEMA-17 DEC (1:28) & R.A. (1:38) motors.

https://www.youtube.com/watch?v=wOYMoVUSzXo

[grozmaistor]

Can you share the covers for the nema17 motors?

[grozmaistor]

Is it possible to use the hand controller  simultaneously with EQMod computer connection?
I have read somewhere in the posts that you have to use just one of the two types.

[tombkk]

Can you share the covers for the nema17 motors?

U P D A T E
-------------
https://www.thingiverse.com/thing:4598951

 
 

[starlights]

hi.
I have a problem whit my handcontroler an astroeqboard.
When i contect the pe0 and pe2 whit a 1k resistor het word whit the handconroller.
But when i whant the use eqmont i most disconect the brig betwin pe2 and pe0. Everwise it wil not work.

Have somone a silion ?

Best regardes Johan