Welcome, Guest. Please login or register.

Username: Password:

Author Topic: 8.05 firmware gt2560 Speed/Coordinates doesnt match  (Read 2404 times)

kaito83

  • Full Member
  • ***
  • Posts: 47
    • View Profile
8.05 firmware gt2560 Speed/Coordinates doesnt match
« on: August 14, 2017, 08:17:42 »
Hi All!

I have updated my board with new firmware, but the slew was very slow I found in the setup  Ustep Gear changing was enabled after I disabled it the movements was double .... everything fine with 7.4
Configuration
8.05/7.4 config:
0.9 - steps
4 - belt ratio
135 - worm ratio
ustep 16
DRV8825

Regards Tamas
Logged

jukkapaavilainen

  • Full Member
  • ***
  • Posts: 10
    • View Profile
Re: 8.05 firmware gt2560 Speed/Coordinates doesnt match
« Reply #1 on: August 14, 2017, 16:30:39 »
I have the same problem! Eny fix?
Logged

TCWORLD

  • Administrator
  • *****
  • Posts: 809
    • View Profile
    • AstroEQ
Re: 8.05 firmware gt2560 Speed/Coordinates doesnt match
« Reply #2 on: August 14, 2017, 17:21:56 »
I'll check over the firmware again. Stay tuned.
Logged
Tom Carpenter (AstroEQ)

TCWORLD

  • Administrator
  • *****
  • Posts: 809
    • View Profile
    • AstroEQ
Re: 8.05 firmware gt2560 Speed/Coordinates doesnt match
« Reply #3 on: August 16, 2017, 08:32:53 »
Did you remember to click the update button when you changed modes?

Also, what go-to speed are you trying to set?

I am struggling to find anything wrong with the code that would cause this behaviour.
Logged
Tom Carpenter (AstroEQ)

kaito83

  • Full Member
  • ***
  • Posts: 47
    • View Profile
Re: 8.05 firmware gt2560 Speed/Coordinates doesnt match
« Reply #4 on: August 16, 2017, 09:24:53 »
Yes I always update before upload, and doesnt matter the goto speeds the tracking was bad also
Logged