Welcome, Guest. Please login or register.

Username: Password:

Author Topic: stepper drivers soldered in reverse  (Read 2062 times)

Jamie16v

  • Guest
stepper drivers soldered in reverse
« on: November 11, 2017, 13:17:33 »
well, i have only gone and soldered my stepper drivers in reverse....  >:(
im not very good at desoldering. anybody have any suggestions please?.
Logged

Jamie16v

  • Guest
Re: stepper drivers soldered in reverse
« Reply #1 on: November 19, 2017, 19:33:54 »
well my solution here was to use a heat gun, while it did work, i lent hand from my missus and whilst getting the last of the pins out, we managed to scorch the board and lift some of the tracks. possibly repairable but i decided i could do without the hassle and bought a pre-built unit.
Logged

rvaneynd

  • Full Member
  • ***
  • Posts: 29
    • View Profile
    • Q-Astro
Re: stepper drivers soldered in reverse
« Reply #2 on: November 28, 2017, 18:15:41 »
Jamie,

If the motors are working but in reverse you can tell the AstroEQ of this. I have the same with mine and just to AstroEQ to go Backward on the RA or DEC, which ever is reversed.

Raoul.
Logged