Welcome, Guest. Please login or register.

Username: Password:

Author Topic: 1/16 ustep issue  (Read 2249 times)

passing

  • Jr. Member
  • **
  • Posts: 9
    • View Profile
1/16 ustep issue
« on: November 21, 2017, 07:17:51 »

Hi, I just buy an ASTROEQ controller and I´m happy with - thank You !
 
 When I set 32 ustep level, everything work ideal, sidereal and slew speeds works fine, goto works fine, but then I have a slow iVal.
For my mount with it´s own gears i need set 1/16 ustep level, then I have iVal=307 . Problem is sidereal speed in 1/16 ustep level. Motor do full steps at sidereal speed. But when I use slew speed over 200x sidereal / W or E button at EQMOD /, motor starts make usteps with right speeds.

 I use version 4.7 and my settings for RA axis are:
 
 Motor Driver IC type : 882x
 uStep Gear Changing : enable
 Motor ustep Level : 16
 Motor Step Angle : 1.8 °
 Motor Gear Ratio : 22
 Worm gear ratio  : 60
 Goto Rate /x sidereal/ : 816

 Motor curent is 1,2 A      / 0.6 V  at Vref pin /.

 I tried different settings but always with the 1/16 setting did the full steps at sidereal speed and slew speeds less than 200x sidereal. With 1/8 usteps level all works fine again.
 Can you advise me how to solve this problem please?

 Thanks, Peter.
Logged

TCWORLD

  • Administrator
  • *****
  • Posts: 809
    • View Profile
    • AstroEQ
Re: 1/16 ustep issue
« Reply #1 on: November 21, 2017, 08:16:39 »

Could you try the Beta version from the R&D section of the forum and see if the problem persists.

I think there is an issue with 1/16 stepping and the DRV8825 in the last release firmware that should be fixed in the beta.
Logged
Tom Carpenter (AstroEQ)

passing

  • Jr. Member
  • **
  • Posts: 9
    • View Profile
Re: 1/16 ustep issue
« Reply #2 on: November 29, 2017, 11:32:50 »

Hi, thanks for reply. A beta version has solved the microstepping issue. Now I need to solve a meridian flip. I do not need it ( fork mount ) and EQASCOM settings.

 Thanks again !

 Peter
Logged

passing

  • Jr. Member
  • **
  • Posts: 9
    • View Profile
Re: 1/16 ustep issue
« Reply #3 on: December 23, 2017, 20:11:10 »

Hi, I managed to solve the meridian flip but it took a few moments. Just enough to understand EQMOD behavior. After setting EQMOD I can use GOTO all over the sky.
 I'm delighted that Tommy shared this project, it helped me a lot.

Thank you and I wish you marry Christmas !

Peter
Logged