Welcome, Guest. Please login or register.

Username: Password:

Author Topic: Changing the driver board.  (Read 2194 times)

Steelfixer

  • Full Member
  • ***
  • Posts: 26
    • View Profile
Changing the driver board.
« on: August 20, 2018, 19:58:16 »
would it be possible to use this driver board in the photo.
If it is I can then use 24 volts to drive my nema 23  motors.
« Last Edit: August 20, 2018, 20:02:01 by Steelfixer »
Logged

TCWORLD

  • Administrator
  • *****
  • Posts: 809
    • View Profile
    • AstroEQ
Re: Changing the driver board.
« Reply #1 on: August 21, 2018, 09:50:05 »
Should be possible assuming interface is 5V.

You'd need to disable gear changing in the config utility, and select a microstrip mode that corresponds to the driver settings as the AstroEQ won't be able to change the microstepping mode of that driver.
Logged
Tom Carpenter (AstroEQ)

Steelfixer

  • Full Member
  • ***
  • Posts: 26
    • View Profile
Re: Changing the driver board.
« Reply #2 on: August 21, 2018, 21:58:28 »
Thanks Tom.
I will give it a try.
Logged