Welcome, Guest. Please login or register.

Username: Password:

Author Topic: Huston I have a problem.  (Read 2053 times)

Steelfixer

  • Full Member
  • ***
  • Posts: 26
    • View Profile
Huston I have a problem.
« on: March 10, 2019, 16:06:59 »
I have finished making my very large GEM mount and have come to wire in my Nema 17 stepper motors.

Configured the box of tricks.
To screen shot
Says it is all good when I update.

Go to test with EQMOD and.
on slew speed 1

Press North the motor steps round clockwise.
Press South the motor still steps clock wise.

On Speed 2
Motor just judders back and forth.

on Speed 3
Motor spins in both directions

on Speed 4
Motor starts to turn then stops but still creates a whining noise.

Anyone any ideas please.
« Last Edit: March 10, 2019, 16:14:57 by Steelfixer »
Logged

TCWORLD

  • Administrator
  • *****
  • Posts: 809
    • View Profile
    • AstroEQ
Re: Huston I have a problem.
« Reply #1 on: March 10, 2019, 23:36:04 »
Sounds like you wired the motors up wrong.

The RJ11 connectors are wired out as: xABBAx, where x is no-connect, A is one coil and B is the other coil.

Sounds like you have wired it up as xABABx which would cause the behaviour your describe.
Logged
Tom Carpenter (AstroEQ)

Steelfixer

  • Full Member
  • ***
  • Posts: 26
    • View Profile
Re: Huston I have a problem.
« Reply #2 on: March 13, 2019, 19:03:21 »
Thanks Tom
Logged