Hi Tom,
I am not using AstroEQ PCB. I have made my own Mega2560 version with only two motors, no other connectors.
Previously on myn old laptop, I was able to GoTo without any extra settings.
On my new laptop, I reinstalled everything now and the problem started. But I found the solution.
So, I am using stellariumscope. There I have to select mount. Which I selected HEQ5/6. In that properties, I set the coordinates of my location.
Again in mount settings option, I kept it to auto detect, and it took some random gear ratio and steps. Which was 8 times higher for DEC and 1.2 times higher for RA.
So in that place, I replaced the values obtained from config utility and it worked immediately.
I didn't remember doing this before in my old laptop.
Thanks,