Welcome, Guest. Please login or register.

Username: Password:

Author Topic: loosing eeprom content  (Read 1354 times)

tidobell

  • Jr. Member
  • **
  • Posts: 8
    • View Profile
loosing eeprom content
« on: February 06, 2021, 10:42:36 »

Hello, I have build the EQMOD with arduino mega 2560. i use a laptop with window 10, firmware V3.9.3 and EASCOM V2.00q. I the toolbox the com port is found. I can load the firmware and the configuration for my mount. When that is ready, the program is trying to connect to eascom, then I get out of time message. Then I try a second time, get the same massage. When I restart the config program I cannot communicate. I choose the right com-port but no communication. By selecting configure it says no data in eeprom. The I clean the with the arduino programmer, and I can load the eeprom again. What am I doing wrong?
I tried several mega 2560 boards, but they all give the same problem.
Who can help me?
Logged

TCWORLD

  • Administrator
  • *****
  • Posts: 809
    • View Profile
    • AstroEQ
Re: loosing eeprom content
« Reply #1 on: February 07, 2021, 20:06:17 »

Have you connected a 1k resistor between D21 and D23 as shown in the schematic?
Logged
Tom Carpenter (AstroEQ)

tidobell

  • Jr. Member
  • **
  • Posts: 8
    • View Profile
Re: loosing eeprom content
« Reply #2 on: February 09, 2021, 19:53:39 »

Tom thanks for your help. It is working now.
Logged