Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
DIY AstroEQ / Arduino IDE version for compiling the code
« on: October 01, 2015, 10:14:08 »
Hi Tom,
Could you help to give a hint about how I can compile the source code with the Arduino IDE?
I used Arduino IDE v1.6.5 to compile the code without any problem. But if I use the firmware to download to the board (Arduino Mega or DIY board), the firmware doesn't run normally when doing GoTo. I used Cartes du Ciel (Skychart) for the GoTo test. At first the steppers started normally. But after a few seconds, the status LED stopped blinking and it seemed that the Skychart had lost contact with the board. Is this related to the UART interrupt handling or timer interrupt handling?
Any advise for this issue?
Thanks in advanced!
Leo
Could you help to give a hint about how I can compile the source code with the Arduino IDE?
I used Arduino IDE v1.6.5 to compile the code without any problem. But if I use the firmware to download to the board (Arduino Mega or DIY board), the firmware doesn't run normally when doing GoTo. I used Cartes du Ciel (Skychart) for the GoTo test. At first the steppers started normally. But after a few seconds, the status LED stopped blinking and it seemed that the Skychart had lost contact with the board. Is this related to the UART interrupt handling or timer interrupt handling?
Any advise for this issue?
Thanks in advanced!
Leo
Pages: [1]