Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
DIY AstroEQ / Re: wrong angle
« on: August 17, 2016, 10:52:59 »
Thank you for the quick reply !
I tried to very low speeds and the angle remains strictly the same.
For jumping steps of stepper motor I do not think that's it because the actual angle have to be smaller than the angle required.
I'll check the gear pulleys
I tried to very low speeds and the angle remains strictly the same.
For jumping steps of stepper motor I do not think that's it because the actual angle have to be smaller than the angle required.
I'll check the gear pulleys
2
DIY AstroEQ / wrong angle
« on: August 17, 2016, 00:37:37 »
Hello.
I have a problem angle applied by astroEQ.
I have a GP2.
stepper motor 400 steps
pulley 1: 4
Worm: 1: 144
mega 2560 r3 + 2x drv8825
when I move the axis of declination (or ascention right) of 90 ° according EQmod, the shaft rotates 110 ° (measured on the frame).
I have verified the number of turns per revolution calculated in the interface and is well calculated.
By introducing an angle 3.23676323 pulley ratio is nearly equal to 90 °.
I do not understand why I have this error? Thank you for your help.
I have a problem angle applied by astroEQ.
I have a GP2.
stepper motor 400 steps
pulley 1: 4
Worm: 1: 144
mega 2560 r3 + 2x drv8825
when I move the axis of declination (or ascention right) of 90 ° according EQmod, the shaft rotates 110 ° (measured on the frame).
I have verified the number of turns per revolution calculated in the interface and is well calculated.
By introducing an angle 3.23676323 pulley ratio is nearly equal to 90 °.
I do not understand why I have this error? Thank you for your help.
Pages: [1]