This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Beta Firmware Releases / Re: [Completed] AstroEQ 8.0.3(beta)

« on: April 18, 2017, 17:19:19 »

Hi Tom,
Copied new hex files and all working ok when slewing
Many thanks for all your hard work.
Andy

2

Beta Firmware Releases / Re: [Completed] AstroEQ 8.0.3(beta)

« on: April 16, 2017, 22:32:28 »

Hi Tom

just to confirm I too loaded latest beta release
I click and hold on N and not much happens moves 1 step at a time all other directions are fine when slewing. . I'm using the EQ5 custom pulley config as well.

When I revert back to 7.4 firmware all is well again in all directions using version 4.5 astroeq box

food for thought when you have time after easter break

regards
Andy

3

General Discussion / Re: Belts for nema motors

« on: March 18, 2017, 21:54:52 »

thankyou for the update greatly appreciate this

4

General Discussion / Belts for nema motors

« on: March 18, 2017, 20:46:00 »

H just a quick question for you
you state to purchase  in your tutorial for custom builds for en eq5 with nema 14 motors with the specified motors you suggest and pulleys
2 x Timing Belts (1x 61 Tooth, 1 x 63Tooth) with a 6.35mm width
Which is RA and which is DEC
Regards
andy