Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
AstroEQ Availability / Re: AstroEQ Availability [Currently Unavailable]
« on: July 09, 2016, 16:36:41 »
Hi, Tom...
I'd like to buy one of the units, please. Do you have any available at the moment?
Thanks,
Roger Hill
(just outside of) Toronto, Canada
I'd like to buy one of the units, please. Do you have any available at the moment?
Thanks,
Roger Hill
(just outside of) Toronto, Canada
2
Mount Support / Re: Synchronous Motor Replacement
« on: January 01, 2015, 22:06:09 »
Hmmm...so, not ideal, then.
What would the ideal motor look like? Perhaps it may be possible to either sell the ones I have to, or swap them with, some robotics geek.
Thanks, Tom.
What would the ideal motor look like? Perhaps it may be possible to either sell the ones I have to, or swap them with, some robotics geek.
Thanks, Tom.
3
Mount Support / Re: Synchronous Motor Replacement
« on: January 01, 2015, 20:01:13 »
I have some Sanyo Denki steppers that I'd like to use.
The problem is that I can't find these exact motors listed anywhere, and as a result, I don't know the voltage for them.
I am going to make the assumption that there are people here who may know where I can find this information and point me towards it.
So, I have a few Sanyo-Denki steppers labelled as:
DC 2A, 1.8 DEG, Type 103H7123-0447 . There is a "Lot number" as well, but I suspect it's not significant, as it varies from motor to motor.
Thanks for any help anyone can render.
Roger
Canada
The problem is that I can't find these exact motors listed anywhere, and as a result, I don't know the voltage for them.
I am going to make the assumption that there are people here who may know where I can find this information and point me towards it.
So, I have a few Sanyo-Denki steppers labelled as:
DC 2A, 1.8 DEG, Type 103H7123-0447 . There is a "Lot number" as well, but I suspect it's not significant, as it varies from motor to motor.
Thanks for any help anyone can render.
Roger
Canada
Pages: [1]