Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Capabilities Question / Re: cable remote connected to ST4?
« on: November 08, 2017, 08:44:34 »
Thank you very much and sorry for duplicate question.
2
Capabilities Question / cable remote connected to ST4?
« on: November 02, 2017, 13:49:59 »
Hi,
I just wondering is it possible to build simple cable remote controler (joystick) and connect it to ST4 input? To made final adjustment by hand. If I understand correctly, it is enought to connect one of the 4 ST4 pins to the GND to start to move in some direction. What is the best place to get GND without opening enclosure?
Cheers,
Damian
I just wondering is it possible to build simple cable remote controler (joystick) and connect it to ST4 input? To made final adjustment by hand. If I understand correctly, it is enought to connect one of the 4 ST4 pins to the GND to start to move in some direction. What is the best place to get GND without opening enclosure?
Cheers,
Damian
3
Mount Support / 12V SECM8
« on: October 09, 2017, 09:54:38 »
I use 12V SECM8 stepper motors with maximum coil current 2.8 A, from http://www.astro-electronic.de/
Do anyone have some knowlage that AstroEQ driver is suitable for that type of motors?
Cheers!
Damian
Do anyone have some knowlage that AstroEQ driver is suitable for that type of motors?
Cheers!
Damian
Pages: [1]