Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
AstroEQ Support / Re: Astroeq 4.7 is not configured
« on: November 28, 2017, 14:44:46 »
Thanks Tom, I have managed to discover the error.
Although I followed all the correct indications, I still could not connect.
By simple chance, I tested with another power source and ASTROEQ has connected without problems.
The fault has been that I have been using a 12V connector that is not suitable.
I have compared both sources of energy (voltage, etc.) and I have discovered that the power source that did not work has a different connector.
At first glance they look the same, but the caliber detects the difference between the two, (- 0.4 mm / Ø).
The funny thing is that when you connect it, the ASTROEQ LEDs light up and flash normally, so there does not seem to be a voltage failure.
Regards,
Juanjo
Although I followed all the correct indications, I still could not connect.
By simple chance, I tested with another power source and ASTROEQ has connected without problems.
The fault has been that I have been using a 12V connector that is not suitable.
I have compared both sources of energy (voltage, etc.) and I have discovered that the power source that did not work has a different connector.
At first glance they look the same, but the caliber detects the difference between the two, (- 0.4 mm / Ø).
The funny thing is that when you connect it, the ASTROEQ LEDs light up and flash normally, so there does not seem to be a voltage failure.
Regards,
Juanjo
2
AstroEQ Support / Astroeq 4.7 is not configured
« on: November 27, 2017, 18:36:35 »
Hi.
I received my ASTROEQ a few days ago, and I can not get astroeq to connect.
My laptop is with win10.
I have installed EQASCOM_V200k, ASCOMPlatform63 and AstroEQ-ConfigUtility (Windows Vista / 7 / 8.1 / 10).
First I connect the power to ASTROEQ and then the USB port.
When I start AstroEQ-ConfigUtility, it recognizes the com port, but when I give it to Configure, the message comes out: "Read Failed! Connection unaviable".
When I give Update Firmware, the following message is displayed:
Upload Failed¡¡
I do not know if I'm doing something wrong, or the error is in Astroeq.
Can you help me?
Thank you very much,
Juanjo
PD: Sorry for my bad English
I received my ASTROEQ a few days ago, and I can not get astroeq to connect.
My laptop is with win10.
I have installed EQASCOM_V200k, ASCOMPlatform63 and AstroEQ-ConfigUtility (Windows Vista / 7 / 8.1 / 10).
First I connect the power to ASTROEQ and then the USB port.
When I start AstroEQ-ConfigUtility, it recognizes the com port, but when I give it to Configure, the message comes out: "Read Failed! Connection unaviable".
When I give Update Firmware, the following message is displayed:
Upload Failed¡¡
I do not know if I'm doing something wrong, or the error is in Astroeq.
Can you help me?
Thank you very much,
Juanjo
PD: Sorry for my bad English
Pages: [1]