Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
DIY AstroEQ / Re: Problem uploading on Arduino 2560
« on: January 16, 2018, 23:09:00 »
Thanks for your suggestion, by the way I've tryed updating three different 2560 (of two different producer) without success... the bootloader is updated but the AstroEQ-ConfigUtility continue to fail reading eeeprom.
I've tried also to clear eeeprom with an Arduino skecth without results.
I've tried to update firmware, unplug the 2560 and go on but, in some situation, EQMOD permits the connection the the driver, AR and LST keep scrolling and none command will effect. I believe the problem is that the EEPROM is empty, but how could be modified if AstroEQ-ConfigUtility doesn't work?
Now I have ask some friend if someone got a 1280 and I'll try again... but I'm quite sad for this behaviour.
I've tried also to clear eeeprom with an Arduino skecth without results.
I've tried to update firmware, unplug the 2560 and go on but, in some situation, EQMOD permits the connection the the driver, AR and LST keep scrolling and none command will effect. I believe the problem is that the EEPROM is empty, but how could be modified if AstroEQ-ConfigUtility doesn't work?
Now I have ask some friend if someone got a 1280 and I'll try again... but I'm quite sad for this behaviour.
2
DIY AstroEQ / Problem uploading on Arduino 2560
« on: January 16, 2018, 17:43:16 »
For first, thanks for the admission to this forum.
Yesterday I've started a new AstroEQ using an Arduino Mega 2560 clone, a protoshield and two DRV8825 just tuned for couple of 23HS8610. I've checked every soldering with a multimeter but I got some trouble uploading the firmware: I've installare JRE 8 on a Windows Vista 32bit machine and launched the AstroEQ utility. From the software I can see the COM17 where is attached Arduino 2560 and when I press Upload Firmware seems all working but, when I press Next, the software reply me: Failed connection...
I've tried several times and I've also substituted the Arduino 2560 with another one (previously used on a 3D printer) but without results. I've also tried to upload a Blink skecth from Arduino IDE on the same card and it works fine.
Could be a issue using a 32 bit OS? Should I use a Windows 10 x64 machine?
Thanks in advance for your attention,
Simone
Yesterday I've started a new AstroEQ using an Arduino Mega 2560 clone, a protoshield and two DRV8825 just tuned for couple of 23HS8610. I've checked every soldering with a multimeter but I got some trouble uploading the firmware: I've installare JRE 8 on a Windows Vista 32bit machine and launched the AstroEQ utility. From the software I can see the COM17 where is attached Arduino 2560 and when I press Upload Firmware seems all working but, when I press Next, the software reply me: Failed connection...
I've tried several times and I've also substituted the Arduino 2560 with another one (previously used on a 3D printer) but without results. I've also tried to upload a Blink skecth from Arduino IDE on the same card and it works fine.
Could be a issue using a 32 bit OS? Should I use a Windows 10 x64 machine?
Thanks in advance for your attention,
Simone
Pages: [1]