Welcome, Guest. Please login or register.

Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - newil86

Pages: [1]
1
DIY AstroEQ / Re: AstroEQ + INDI tracking problem
« on: February 19, 2018, 16:50:47 »
Are you using the latest version of the firmware? (V8.11)

There were some major fixes to the AstroEQ firmware in V8.11, specifically related to fixing a myriad of problems with INDI.

I compile firmware from https://github.com/TCWORLD/AstroEQ/tree/master/AstroEQ-Firmware in AtmelStudio. I think it's latest version.

2
DIY AstroEQ / AstroEQ + INDI tracking problem
« on: February 19, 2018, 05:42:15 »
Hello!
I'm sorry if I duplicate this question. I have a DIY AstroEQ with latest firmware. And I have INDI Server on my Raspberry PI 3. I use latest build INDI (Compiled from source). Tracking starts only if I click left or right navigation button. I finded same problem in http://www.indilib.org/forum/mounts/1306-eqmod-tracking-problems.html. I check build and it contains a fix. But problem still exists =/ Who solved this problem?

P.S. Sorry for my bad English...

3
DIY AstroEQ / Re: Question about error "IVal must be <1200"
« on: February 18, 2018, 11:18:10 »


Hello,

Thanks!!! Today i'll be testing this version.
[/quote]

To many thanks! It's work!

4
DIY AstroEQ / Re: Question about error "IVal must be <1200"
« on: February 14, 2018, 06:49:01 »
Hi,

I found a glitch in the config utility which was causing the issue - one of the calculations was iterating too far causing it to ignore perfectly usable IVal options.

I've attached a patched version of the config utility (firmware is unchanged).

Hopefully it should no longer produce the error.

Kind Regards,
Tom.

Hello,

Thanks!!! Today i'll be testing this version.

5
DIY AstroEQ / Re: Question about error "IVal must be <1200"
« on: February 08, 2018, 08:59:24 »
Additionally if you are on the high end of IVal, it means the resolution of the mount is going to be very poor - the DEC axis will move about 3 arcseconds each microstep.

Many thanks!

6
DIY AstroEQ / Question about error "IVal must be <1200"
« on: February 08, 2018, 06:40:53 »
Hello! I have a DIY Astroeq based on Arduino Mega. Motor Nema 17 1.8' and A4988 drivers. Gear ratio = 2. My mount is EQ3-2. When i try to upload config i get an error 'Ival must be <1200' on DEC (my calculated value is ~1380). I can not understand what this limitation. I edited this value to 1400 and build the projects (firmware and UI). After that I was able to load the configuration.
What will affect IVal >1200 on DEC?
Thanks
P.S. Sorry for my bad English...

Pages: [1]