Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
AstroEQ Support / Re: AstroEQ and Windows XP
« on: January 26, 2015, 12:08:46 »
Just wanted to say that I got it all up and running but the only problem now is,
the dec motor gets very hot! I tried rebooting and turning down the current but no changed...?
It works but for how long I don't know...Could there be another problem?
Any help on this would be grateful!
Gilles
the dec motor gets very hot! I tried rebooting and turning down the current but no changed...?
It works but for how long I don't know...Could there be another problem?
Any help on this would be grateful!
Gilles
2
AstroEQ Support / Re: AstroEQ and Windows XP
« on: January 24, 2015, 01:14:09 »
Hi,
Thanks Tom that helped! Just have to work out the motor drive speeds... And the odds and ends
So far so good cant wait to get it all working!!!!
Again thanks!
Gilles
Thanks Tom that helped! Just have to work out the motor drive speeds... And the odds and ends
So far so good cant wait to get it all working!!!!
Again thanks!
Gilles
3
AstroEQ Support / AstroEQ and Windows XP
« on: January 23, 2015, 12:25:42 »
Hello all,
I have just purchased the AstroEQ and I am very excited!
But, I'm running windows xp with sp3 and all updates.
I downloaded all the divers for all and that took some time but now have them all...
All connected to the motors and pc with all the lights working and go to the AstroEq configUtilliy
double click on the astroeq firmware and the utility pops up select the com and not sure about the firmware but use the
main one astroeq v4-diy board...? "V7.3" OK good up until the astroeq configuration setup set all settings and push on the done.
Connect error timeout on the Eqmod heq5/6 ?
I have just purchased the AstroEQ and I am very excited!
But, I'm running windows xp with sp3 and all updates.
I downloaded all the divers for all and that took some time but now have them all...
All connected to the motors and pc with all the lights working and go to the AstroEq configUtilliy
double click on the astroeq firmware and the utility pops up select the com and not sure about the firmware but use the
main one astroeq v4-diy board...? "V7.3" OK good up until the astroeq configuration setup set all settings and push on the done.
Connect error timeout on the Eqmod heq5/6 ?
Pages: [1]