Welcome, Guest. Please login or register.

Username: Password:

Author Topic: PWM pin in Arduino schematic  (Read 1989 times)

GigiG

  • Full Member
  • ***
  • Posts: 28
    • View Profile
PWM pin in Arduino schematic
« on: November 14, 2017, 16:14:22 »
Hi Tom, I've just seen in the schematic (astroeq-arduino-schematic.pdf in Tutorials page) a section of the circuit with a jack (PWM) that points to the Mega's pin 10. I was wondering which function is foreseen for this pin? Thanks and regards
Logged

TCWORLD

  • Administrator
  • *****
  • Posts: 809
    • View Profile
    • AstroEQ
Re: PWM pin in Arduino schematic
« Reply #1 on: November 14, 2017, 17:26:22 »
Basically nothing yet.

I had envisaged it to be able to drive a polar-scope LED, or RDF. There is a command in the skywatcher protocol that could be used for that, but I don't think EQMOD implements it.

If I ever got around to using it for something it would need to be on pin 10 of the Mega to ensure consistency in the code - specifically to be on the same timer output as the ATMega162.
Logged
Tom Carpenter (AstroEQ)